Titan Forge Airsoft
CTM Hi-Capa HPA M4 Magazine Adapter
CTM Hi-Capa HPA M4 Magazine Adapter
Couldn't load pickup availability
This is the baseline route to HPA for a Hi-Capa: a vertical adapter that replaces the gas magazine with an AR/M4 one fed from an external air rig. The reason to bother is consistency. A regulated tank delivers the same pressure shot after shot however cold the morning is, where green gas tails off as the can and the weather cool, and you inherit a rifle magazine's round count into the bargain.
It keeps the magazine hanging straight, which suits open shooting positions and a conventional draw, and there is a keyring slot moulded into the body, handy for tethering a tool or just adding a bit of personalisation.
It is moulded from glass-reinforced nylon with a CNC 6061 aluminium magazine release and fits WE, Armorer Works, Tokyo Marui, KJW and SSP Hi-Capa pistols. It takes PTS Syndicate SpeedQB EPM magazines as well as other AEG M4 mags.
Specifications
| Specification | Detail |
|---|---|
| Body | Glass-reinforced nylon, injection moulded |
| Magazine release | CNC 6061 aluminium |
| Pistol fit | WE, Armorer Works, Tokyo Marui, KJW, SSP Hi-Capa |
| Magazine fit | PTS Syndicate SpeedQB EPM and other AEG M4 magazines |
| Operating pressure | 0–140 psi via low-pressure regulator; around 120 psi typical |
| In the box | Adapter with rubber ring, 2.5 x 100 mm hex head with nylon gasket, universal feed tube |
| Colours | Black / Grey, Blue / Silver, Red / Gold, Violet / Green, Black / Electroplated Gold, Black / Electroplated Rainbow |
Good to know before you buy
If you reload a lot, the matching CTM CNC magwell drops straight onto this adapter for a faster, funnelled magazine change.
Frequently asked questions
Straight or angled - which should I buy?
Straight, unless you spend time prone or tucked into cover. This one hangs the magazine vertically, which suits an ordinary draw and open positions. The angled version rakes it back to clear the ground.
What pressure do I run it at?
0 to 140 psi through a low-pressure regulator, and around 120 psi is typical. Do not go past 140 - above that you are wearing the pistol's internals out. Set it with an HPA regulators.
What else do I need to buy?
An AEG M4 magazine, a regulated tank and a line ending in a Foster coupler. None of those are in the box. The complete HPA guide walks through choosing the air side.
Share





